Multi-Tech FR3100 Manual de servicio descargar pdf (Pagina 18)

4 - 3

■ ENTERING THE ADJUSTMENT MODE

1 Turn the power OFF.

2 While pushing and holding both [CH-DN] and [CH-UP],

turn ON. Never release [CH-DN] and [CH-UP] until 1

short beep sounds.

3 Push [CH-DN] button, then sounds 2 beep audio.

■ OPERATING IN THE ADJUSTMENT MODE

• Change the item (including frequency) (+1). : Push [CH-UP] button.

• Change the item (including frequency) (–1). : Push [CH-DN] button.

• Adjust the specified value (+1). : Push [PRT/BASE] button.

• Adjust the specified value (–1). : Push [MONI] button.

• Change the TX and RX’s condition. : Push [PROG] button.

Change the condition TX reference frequency to RX reference frequency.

Change the condition TX “HIGH POWER” to TX “LOW POWER”.

■ EXITING THE ADJUSTMENT MODE

1 Turn the power OFF.

2 While pushing and holding and [CH-UP], turn ON. Never release [CH-UP] until 1 short beep sounds.

3 Push [CH-UP] button, then sounds 2 beep audio.

■ AFTER FINISHING ADJUSTMENT

CAUTION!: When the adjustment is finished, the repeater need to be canceled adjustment mode.

Otherwise the repeater does not work properly.

1 Perform the step 1 to 4, described in the PROCESS TO PERMIT “ADJUSTMENT MODE ACCESS” (see page 4-2).

2 Click the “EXPERT 2” tag, then clear the check box for the “Adjustment Mode Access”.

3 Click “OK” button, then cloning with the original memory data.

[POWER]

[CH-UP]

[CH-DN]

[CH-UP]

[CH-DN]

[RPT/BASE]

[MONI]

[PROG]

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 70 71

Sin comentarios

Multi-Tech FR3100 Manual de servicio Pagina 18